What counts as usable roof access for a tower crew

A roof with a ladder bolted to the parapet gets flagged "accessible" on more search ring packages than it should. Ladders get a tech to the roof. They don't get a crew, a compressor, six panel antennas, a tower-mounted amplifier, and 200 feet of coax hoisting cable up there. That's the gap that turns a clean candidate list into a field crew standing on a sidewalk calling the office.
Usable roof access for a tower crew means a documented path, from the loading dock or street level all the way to the roof plane, that a crew can move equipment through without renting a crane or cutting a hole in someone's ceiling. That's a different question than "can a person get up there," and it's the one that determines whether a rooftop candidate survives past the site walk.
Why a ladder doesn't settle the question
A ladder answers one question: can a single person with a tool bag climb to the roof. It says nothing about whether a four-person crew can bring up an ice bridge, a GPS mount, battery cabinets, or a new RRU without disassembling it piece by piece and reassembling it on the roof deck, which adds labor hours nobody budgeted for and sometimes voids equipment warranties that specify factory assembly.
Fixed exterior ladders also tend to come with fall-protection and OSHA-compliance questions that a general contractor's building engineer may or may not have answers for on day one. None of that shows up on a satellite image, and most of it doesn't show up until someone's standing at the base of the ladder with a cart full of gear and nowhere to put it.
Freight elevator access and hatch width, the two measurements that matter most
If the building has a freight elevator, the car dimensions and door width set a hard ceiling on what goes up in one piece. A standard passenger elevator is usually too narrow and too short for an antenna panel longer than about 6 feet, which means the crew either sources a smaller antenna model, which isn't always an option on a carrier-specified build, or breaks the lift into multiple elevator runs and reassembles on the roof.
Roof hatches have the same problem in miniature. A hatch opening under roughly 30 inches square turns every piece of equipment into a puzzle: does it fit through at this angle, does the conduit bend around the hatch curb, can two people maneuver a cabinet through without scraping paint off a $40,000 unit. Narrow hatches also usually mean no permanent ladder below them, just a straight vertical climb, which adds another access question on top of the width one.
Neither of these numbers is something you can eyeball from a rooftop photo. They're building-specific, and on an older structure they're often undocumented anywhere except the building engineer's memory.
What actually needs confirming before a crew gets dispatched
A site acquisition specialist working a search ring is checking four things before calling a rooftop a candidate: a hoisting path that doesn't require a crane, a hatch or elevator opening wide enough for the equipment package the carrier specified, a walking surface and tie-off points that meet the roofing membrane warranty terms, and a landlord or building engineer who'll sign off on a path through their building.
None of that replaces a site walk. What it does is tell you which rooftops in a ring are worth walking in the first place, and which ones have an access problem severe enough that no lease negotiation fixes it. Screening a search ring for structures with workable height and clearance before a crew gets routed to the wrong roof is exactly the step that sits between pulling a basemap and sending a surveyor out with a tape measure.
Get the rooftop and clearance list first, then spend the site walk confirming access instead of discovering it.